Artículos Técnicos

Time-Dependent Behavior of Saint-Martin-La-Porte Exploratory Galleries: Field Data Processing and Numerical Modeling of Excavation in Squeezing Rock Conditions

Yichun Liu, Ph.D.1; Jean Sulem, Ph.D.2; Didier Subrin, Ph.D.3; Huy Tran-Manh, Ph.D4.

1. Laboratoire Navier, CERMES, Ecole des Ponts ParisTech, Univ. Gustave Eiffel, CNRS, 6–8 Avenue Blaise Pascal, 77455 Marne-la-Vallée, France. ORCID: https://orcid.org/0000-0002-9634-9797.
2. Laboratoire Navier, CERMES, Ecole des Ponts ParisTech, Univ. Gustave Eiffel, CNRS, 6–8 Avenue Blaise Pascal, 77455 Marne-la-Vallée, France (corresponding author). ORCID: https://orcid.org/0000-0001-9851-3936.
3. Centre d’études des tunnels (CETU), 25 Avenue François Mitterrand, 69500 Bron, France
4. Itasca Consultants SAS, 29 Avenue Joannes Masset, 69009 Lyon, France

Abstract

Field monitoring programs (e.g., convergence measurements and stress measurements in the support system) play an important role in following the response of the ground and of the support system during and after excavation. They contribute to the adaptation of the excavation and support installation method and the prediction of the long-term behavior. In the context of the Lyon–Turin link project, an access gallery (SMP2) was excavated between 2003 and 2010, and a survey gallery (SMP4) has been excavated since 2017. Both tunnels are excavated in Saint-Martin-la-Porte (France) across a strongly tectonized Carboniferous formation, which is highly fractured and heterogeneous. Squeezing behavior has been observed and led to the instability of the support system and of the tunnel face in various locations. Based on the knowledge gained from field data processing and numerical modeling in SMP2, new field data are analyzed for SMP4, which is excavated at a much deeper depth, with a different orientation and with different excavation methods. Numerical modeling of the various profiles of SMP4 considering the excavation stages and the specific yielding support is presented, which predicts the time-dependent response of the tunnel.

Últimas noticias
  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
    Leer mas
  • Primer Anuncio 6º Simposio Itasca sobre Modelado Numérico Aplicado se llevará a cabo del 3 al 6...
    Leer mas
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....
    Leer mas

Próximos Eventos
19 nov.
Getting Started with FLAC2D/FLAC3D
This training is an introduction to continuous modeling with FLAC2D and FLAC3D. At the end of the course, participants will master the ... Leer mas